[atlas-sw-probes] How to force the SW Probe to use particular IP Interface / IP Address?

Yes now it works fine, my 1000069 now shows correct "Local Address" and is not marked "IPv4 RFC1918" anymore. Thank you for that.

Regarding measurements I see what you mean. I think we can live with it...

Thanks again
Jiri



______________________________________________________________
> Od: "Philip Homburg" <philip.homburg at ripe.net>
> Komu: atlas-sw-probes at ripe.net
> Datum: 18.06.2020 18:03
> Předmět: Re: [atlas-sw-probes] How to force the SW Probe to use particular IP Interface / IP Address?
>
>On 2020/05/25 16:28 , ripe at brite.cz wrote:
>> Probe Address Discovery
>> 	IPv4 	IPv6
>> Connection Address 	- 	2a01:510:xxxx:4888::1
>> IP Echo Service 	95.85.x.x 	2a01:510:xxxx:4888::1
>> The Local IP 	192.168.1.1 	2a01:510:xxxx:48ff::1 
>
>We have improved the selection of the local IPv4 and IPv6 addresses.
>Basically we prefer address from interfaces that have a default route.
>
>This particular problem should now be solved. Please let me know if
>something is wrong.
>
>> For IPv6 it is different story. On the web page all the IPv6 are listed correctly, but measurements show "src_addr":"2a01:510:xxxx:4888::1" as well as the "Connection Address" does. While the Default Route it different interface with something like 2a01:510:d5:xxxx:xxxx:xxxx:xxxx:xxxx address.
>
>For measurements, address selection is done by the Linux kernel. As far
>as I can tell, what happens here is that the interface with a default
>route (pppoe-wan) doesn't have a global IPv6 address. So the kernel has
>no way to prefer one address over another.
>
>Philip
>
>
>