[atlas-sw-probes] How to force the SW Probe to use particular IP Interface / IP Address?
- Previous message (by thread): [atlas-sw-probes] How to force the SW Probe to use particular IP Interface / IP Address?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Philip Homburg
philip.homburg at ripe.net
Mon May 25 16:30:20 CEST 2020
On 2020/05/25 16:24 , jsuchan at centrum.cz wrote: > - how can I have my probe 1000069 not tagged IPv4 RFC1918? There is not much that can be done here. It is an automated process. Of course removing all interfaces with RFC 1918 addresses would do the trick. > - how can I make the probe use the default outgoing interface mentioned above? The probe just reports all of it's addresses. It is our backend system that needs to be improved. I can see that this is an issue. But I don't know how busy the people are who should implement this change. Philip
- Previous message (by thread): [atlas-sw-probes] How to force the SW Probe to use particular IP Interface / IP Address?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]